Fast Convergence Techniques: IS-IS

We would be irresponsible as network designers if we did not study and appreciate IS-IS for the problems it can solve. IS-IS is a link-state protocol similar to OSPF. IS-IS uses TLVs (similar to BGP), and is thus easily extended. IS-IS and OSPF are the two choices you have when deploying TE on MPLS networks, so you should know how IS-IS compares with OSPF when your design requires fast convergence. Cisco has several resources on their site, which I’ve distilled into a few rules of thumb:

  1. Increase LSP refresh timer to a high value
  2. Increase MAX LSP lifetime to a high value
  3. Tune PRC interval
  4. Tune SPF interval
  5. Tune LSP generation interval
  6. Use BFD in lieu of fast hellos (on multiaccess networks)
  7. Tune ISIS retransmit interval
  8. Set overload-bit on startup
  9. Disable hello padding
  10. Use a single IS type where possible (note that Cisco default is L1/L2)
  11. Use metric-style wide (not necessarily FC related, but is req’d for TE)

Also related: use isis mesh-group and configure point-to-point interface type on multiaccess interfaces where they are really point-to-point (think 2-member Ethernet segments).

References:
Cisco Technology Support Page
Cisco IOS 12.4 IS-IS Fast Convergence
Cisco Configuration Example

Share/Save/Bookmark